There are several tips that you can use for wood fence repair.
Components
The first tip is to make sure that you know all of the components. Most of the time, a wood fence will have a lot of posts, screening materials, and rails. The rails of the fence will stretch horizontally between the posts when the posts will run vertically. The screening material will be made of boards or pickets. It is a good idea to examine the components of the fence once a year. This is the best way that you will be able to correct any issues with the fence before they become a bigger hassle later on down the road for you and your family.
Rails
The second tip is to make sure that you know how to fix any of the loose rails in the fence. This is when you will need to know which one of the posts that you will be able to use again and the ones that you need to throw out. Most of the time, you will be able to fix them with wooden boards and metal T-braces. Any of the damaged areas that you are attempting to fix will need to have a wood preservative on it. This is the best way to make sure that the rot is contained. It is also important to make sure that you install a cleat to support the fence properly.
The third tip is to make sure that you have the ability to replace the rails. Of course, this is going to depend on the joints. If they are too rotted, then you will probably have to switch out the whole rail. This means that you will need to disassemble the damaged part of the fence so that you will be able to rebuild it. There is a chance that you might have a rail that will space one or two segments. But you will need to measure each one of the rails separately because space will be different. The rails will need to be replaced up to 12 inches up from the ground.
Screening
The fourth tip is that you need to know how to repair the screening of the fence. It is important to remember that it is going to take a few hours. You can use the boards that you cut down of the existing screening because the measurements are going to be the same. Before you actually stop to cut anything, you need to use a carpenter’s square. In order to properly cut the boards, you will need to place a piece that is not broken over the new board. This will allow you to trace the openings. You can use a keyhole saw, coping saw, or saber saw to cut them out.
Post
The fifth tip for fence repair is to know how to make a wood fence post. Sometimes the posts of your fence will become loose, so it will need to be steadied. In order to take the post, you will have to make a new base. You can do this by using the boards that reach at least 18 inches above the ground. When you are installing them, you want to make sure that they extend below the frost line of the area. This is one of the main reasons that you will need to use a material that has been pressure treated like redwood or cedar. If you need something that is more permanent, then you will need to dig the soil out from around the post in order to add concrete to the base.
